10 Panel Drug Test

This is a 10 Panel Multi-Drug Test Card. It has 10 panels (ten parameters) to test for 10 types of drugs. This is an all inclusive drugs of abuse Dip Test for drug screening of ten drugs at one time. This dip strip tests for the following drugs:

THC (MARIJUANA) • COCAINE • PCP • OPIATES • METHAMPHETAMINES • METHADONE • AMPHETAMINES • BARBITURATES • BENZODIAZEPINES • Tricyclic Antidepressants

Our 10 Panel Test is a rapid One-step Diagnostic Drug of Abuse Test to Screen for Ten (10) targeted Illicit and Prescription Drugs and their Metabolites at the Minimum Cutoff Sensitivity Levels Established by the National Institute on Drug Abuse, World Health Organization (WHO) and SAMHSA. Approximately 95% of abused drugs in use today are detectable using this one simple, easy to use, drug testing device. An economical, all inclusive drug of abuse scan for rapid point of contact results. Indicated for pre-employment screening and general testing when drug use is suspected and the specific abused drug is unknown.

This Multi-Drug 10 Panel Test is an forensic, all inclusive, point of use screening test for the rapid detection of 11-nor- delta 9 -Tetrahydrocannabinol -9- carboxylic acid (THC/Marijuana), Cocaine and its metabolite, benzoylecgonine, PCP (Phencyclidine), Morphine and its related metabolites derived from opium (opiates), Methamphetamines (including Ecstasy*), Methadone, Amphetamines, Barbiturates, Benzodiazepines and Tricyclic Antidepressants (TCA) in human urine at or above the system concentrations levels established as standard minimums by the National Institute on Drug Abuse (NIDA), the World Health Organization (WHO) and SAMHSA as shown in the chart to the right. Note system cut-off concentrations are expressed in nanograms per milliliter solution.
*While Methamphetamine tests will generally detect MDMA (Ecstasy), an MDMA specific test is recommended when screening specifically for MDMA or Ecstasy use.

SUMMARY AND EXPLANATION OF DRUG TESTING

Urine based screening tests for drugs of abuse range from simple immunoassay tests to complex analytical procedures. The speed and sensitivity of lateral flow based immunoassays identical to that employed in our Multi-Drug 10 Panel Drug Test have made them the most widely accepted method for screening urine for drugs of abuse. our Multi-Drug Screen Panel Test is based on the principle of the highly specific immunochemical reactions of antigens and antibodies which are used for the analysis of specific compounds in human urine. This Multi-Drug Screen Test is a rapid, visual, competitive panel immunoassay that can be used for the simultaneous, qualitative detection of the ten (10) targeted drugs and their metabolites listed above. For a description of these drugs of abuse along with other useful background information please refer to the Drug Test FAQ page. This Ten Panel Multi-Drug Test is intended as an initial forensic screen for the presence of drug or drug metabolites at the time the test is performed. Because the test requires visual interpretation, it is recommended that a person other than the test subject interpret test results.

SYMBOL	TARGET DRUG	CONC.
THC	MARIJUANA	50 ng/ml
COC	COCAINE	300 ng/ml
PCP	PHENCYCLIDINE	25 ng/ml
OPI	OPIATES	2000 ng/ml
MET	METHAMPHETAMINE	1000 ng/ml
MTD	METHADONE	300 ng/ml
AMP	AMPHETAMINE	1000 ng/ml
BAR	BARBITURATES	300 ng/ml
BZO	BENZODIAZEPINES	300 ng/ml
TCA	TRICYCLIC ANTIDEPRESSANT	1000 ng/ml

DRUG TEST PROCEDURE

1. Read the enclosed instruction manual completely.
2. Do not open the sealed test pouch until just prior to sample testing.
3. Collect a fresh urine sample in a clean container preferably glass.
4. Check the expiration date and remove the test device from the sealed pouch. Do not use the test past its expiration date. Remove the test cap exposing the 10 absorbent wicks. Do not touch the wicks or otherwise contaminate them.
5. Dip the wicks only into the urine sample for approximately 20-30 seconds or until visible sample migration up the wicks and across the tests panels is observed.
6. Dip only the wicks. Do not allow the sample to come in contact with any other part of the test device or its plastic housing.
7. Read result within 3 to 8 minutes after the addition of samples. Do not read result after 8 minutes. If the drug test is left standing for longer than 8 minutes, the intensity of the colored lines may change or for technical reasons, a faint line may appear that should not be interpreted.
8. Photocopy both sides of the test card for a permanent record of test results.

INTERPRETATION OF DRUG TEST RESULTS

Negative: Colored lines adjacent to each target drug name and in the control (C) regions will appear. The color intensity of the line for the target drug may be weaker or stronger than that of the control line however any line, no matter how faint should be interpreted as a negative result. Do not attempt to correlate the intensity or color of the test lines between the targeted drug panels. Also because development times vary for each target drug, results should not fully interpreted until 6-8 minutes have elapsed. Some drug panels, however, will develop test lines within 3 minutes or less producing negative results. A very faint line on the test region may indicate that the target drug in the sample is near the cutoff level for the test. While these results should be considered negative, confirmation of the sample by more analytical testing methods may be desired.
Positive: Colored lines appear in the control regions (C) but do not develop in the test region. The absence of any line in any target drug test region indicates a positive result for that drug or drug metabolite. The example shown is a positive test for THC and Opiates and negative test for all other drugs. Note that test lines are not of equal intensity or color. Because of the various sensitivity cutoff level for each specific drug this result is normal.
Invalid: No line appears in the control region. Under no circumstances should a positive sample be identified until the control line (C) forms in the control test area. If the control line (C) does not form, the test result is inconclusive and the assay should be repeated with a new test device.
Note: our Multi-Drug 10 panel test is used to obtain visual qualitative result and is not intended as a quantitative assay.. This assay provides only a preliminary analytical test result as to the presence of the target drug and drug metabolites at the established minimum standards above. A more specific alternative chemical method must be used in order to obtain a confirmed analytical result. Gas chromatography! mass spectrometry (GC/MS) has been established as the preferred confirmatory method by the Substance Abuse Mental Health Services Administration (SAMHSA). Clinical consideration and professional judgment should be applied to any drug of abuse test result, particularly when preliminary positive results are indicated. If confirmation of positive drug test is required, we suggest Laboratory Confirmation of positive drug test results.

Our Multi-Drug 10 Panel Drug Test Card tests for approximately 95% of the abused illicit and prescription drugs in one simple to use, easy to read, all inclusive device. Test cassettes are individually and hermetically sealed in a foil package clearly stamped with lot number and expiration date. A comprehensive instruction sheet is included covering greater detail on test procedure, clinical accuracy and cross-reactivity charts. This Multi-Drug 10 Panel test is available in any quantity. For bulk quantities and discount prices, call 801-596-2709.

INTENDED USE OF DRUG TEST KIT

SUMMARY AND EXPLANATION OF DRUG TESTING

DRUG TEST PROCEDURE

INTERPRETATION OF DRUG TEST RESULTS

See Also our New 12 Panel Drug Test which covers even more drugs!